| Angle 1 |
<angle value> between 110° and 179°
- Sets angular curvature of branch at End1.
|
| Angle 2 |
<angle value> between 20° and 89°
- Displays angular curvature of branch set proportionally at End2.
|
| Connection 1 | Length (L1) Inlet | Length
|
Positive <numeric value>
- Sets the straight length at End1.
|
| Connection 2 | Length (L2) Outlet | Length
|
Positive <numeric value>
- Sets the straight length at End2.
|
| Connection 3 | Length (L3) |
Positive <numeric value>
- Sets the straight length at End3.
|
| Connection | End Type |
fl -<numeric value>
- Sets and sizes end with a flange connection.
m -<numeric value>
- Sets and sizes end with a male connection.
fe -<numeric value>
- Sets and sizes end with a female connection.
Separate End Type entries for each End Spec with a semi colon. Example: fl-2;fe-.13 creates a flange at End1 with size 2, and a female connection at End2 with an overall reduction of component's dimensions of .13
|
| Inlet | Outer Diameter |
Positive <numeric value>
|
| Inlet | Vertical Distance Inlet to End1 Horizontal Distance
|
Positive <numeric value>
- Sets the distance between the End1 connect point and the divergence point of the heel (End3) center line.
- Sets the distance between the End1 connect point and the End2 center line for trap fittings.
|
|
Inlet to Trap Seal Height
|
Positive <numeric value>
- Sets the distance between the center line at the bottom of the trap to the End1 connect point.
|
| Inlet to Outlet Horizontal Distance |
Positive <numeric value>
- Sets distance between End1 and End2 center lines.
|
| Inlet to Tap Vertical Distance |
Positive <numeric value>
- Sets the distance between the tap (End3) center line and the top surface of the outlet flange (End2).
|
| Outlet | Vertical Distance End1 to Outlet Horizontal Distance
|
Positive <numeric value>
- Sets the distance between the inlet (End1) center line and the bottom surface of the outlet flange (End2).
|
| Outlet to Trap Seal Height |
Positive <numeric value>
- Sets the distance between the center line at the bottom of the trap to the End2 center line.
|
| Outlet | Outer Diameter |
Positive <numeric value>
- Reduced branch outside diameter.
|
| Radius 1 (R1) |
Positive <numeric value>
- Sets center line radius for trap side branch curvature at End1.
|
| Radius 2 (R2) |
Positive <numeric value>
- Sets center line radius for trap side branch curvature at End2.
|
| Tap Length |
Positive <numeric value>
- Sets the straight length of the tap (End3).
|
| Tap Outer Diameter |
Positive <numeric value>
- Sets the tap (End3) outside diameter.
|
| Transition1 Length, Transition2 Length,
Transition3 Length |
Positive <numeric value>
- Sets the transition length. Transitions coupled at End1, at trap and at End2 respectively.
|
| Trap Seal Height |
Positive <numeric value>
- Sets the distance between the main branch (End1/End2) and the heel (End3) center lines.
- Sets the distance between the End1 center line and the trap center line.
|
